PEAVEY GRAPHIC EQ WITH FLS Reviews
More Picture
PEAVEY GRAPHIC EQ WITH FLS Feature
- 150 watts into 4-ohm (2 x 8 ohm) speakers
- 8 balanced XLR microphone inputs
- Tape/CD inputs
- Reverb level control on each channel
- Line Out for connection to external amplifiers
Return input for connection of external effects processors Record Out for taping RF interference protection on all inputs 3-PIN LOW-IMPEDANCE MICROPHONE INPUT - This input is for typical balanced, low-impedance microphones. It will automatically provide phantom power (15V) for condenser mics or active direct boxes. This has an input impedance of 1k ohms. The connector is wired as - Pin 1=shield; Pin 2=positive (hot); Pin 3=negative (cold). 1/4 LINE/HIGH-IMPEDANCE INPUT - This input may be used as either a high-impedance microphone input or for line-level devices such as a cassette player, CD player, video projector or laptop. This will also allow connection from an electric guitar, bass or keyboard. It is a two-conductor input with an impedance of 10k ohms. LEVEL CONTROL - The level control for each channel sends the signal to the master mix bus. Typical operation is between 4 and 8 (dependent upon the input devices) but should be lower than the master level. Please remember that this acts like a preamp, so if you are using a device that has a volume output control (i.e. - a tape or CD player) you will need to do some level matching by adjusting the level controls on each unit TREBLE TONE CONTROL - This is used to adjust the overall tone of the individual inputs. Since it is a cut or boost control (+/-15 dB), it willadd or diminish presence frequencies in the sound beginning at 2 kHz BASS TONE CONTROL - This is used to adjust the overall tone of the individual inputs. Since it is a cut or boost control (+/-15 dB), it will add ordiminish bass frequencies in the sound beginning at 300 Hz REVERB CONTROL - This is used as a send control to the effects bus. It controls the amount of reverberation added to the input signals. MASTER LEVEL - This controls the overall volume level of the entire amplifier. Typical operation is between 4 and 8. EFFECTS VOLUME - This controls the level of the echo and d
Go tO Store Now !!
Dec 28, 2010 10:55:04
0 comments:
Post a Comment